User's Manual

• If soft labels are used, RX ‘Sweep’ is recommended to be set to ON. Set RX ‘Sweep’
OFF if only hard tags are used.
• Set the sensitivity of receivers (window “RX”). Gain is correct, if window "input level"
shown on the computer screen is in green or green/yellow. Gain is acceptable, if "input
level" is in yellow. If "input level" is in red, it is recommended to decrease the gain for the
RX channel. Factory setting is 9 for optimal receiver sensitivity. Test the detection using
all types of tags and labels in all 3 positions to check the receiver sensitivity.
• If the detection is not acceptable, modify the RX detection criteria as Standard
Detection, Best Detection, etc....
• Set up sound and light alarms (type of beeping, time duration, etc...).
• Test jammer detection using a test jammer.
• Set up and test the Internet connection between the system installation site and service
office (if remote monitoring is used).
• Turn ON the power supply for Booster Bag/Foil Lined Bag System by plugging in the 15
VAC Power Transformer.
• Choose the Booster transmit frequency from available 4 frequencies. Set up different
Booster transmit frequencies when installing more Booster transmitters near each other.
The Minimum distance for using the transmitters with same frequency is 10 meter. The
minimum distance also depends on surroundings at the place of installation.
• Check the level of TX power of Booster Bag/Foil Lined Bag detector and adjust it if
necessary. Maximum allowable power setting is 100%.
• Test the Booster Bag/Foil Lined Bag detection using the test Booster Bag/Foil Lined
Bag. The Booster Bag/Foil Lined Bag receiver can also be set to block the alarms
triggered by heavy metal objects such as shopping carts, baby strollers and trolleys.
Adjust the “CADDY” to block such alarms.
• Turn ON the power supply for Magnet Detector by plugging in the 15 VAC Power
Transformer.
• Test the Magnet Detector using a test magnet. Adjust the sensitivity “SENS” of the RX
Magnet Detector board, if needed.
• Perform a final test on the Power of 4™ system (EAS, Booster Bag/Foil Lined Bag,
Magnet and Jammer Detector) before wrapping up installation process.
• Observe the Power of 4™ system for several minutes and re-tune the system if
necessary.
USSProducts\Powerof4™\User’sManual Page5