User's Manual

11
MONO82_USR_MAN_REV_A
This document was created to provide intended recipient documentation of requested device for technician purposes only. Any other usage of this document is an illegal and unlawful act. This document is a confidential and proprietary
document of Universal Surveillance Systems and consist of i nformation what can be protected by copyri ghts or the others intellectual property protection instruments of the others subjects. All other informa tion, what are not generally
known ones, is an intellectual property of Universal Surveillance Systems. This document including any and all attachments hereto is intended solely to be used by individual or entity to which it is addressed. If the reader of this
document is not the intended recipient, or an employee or agent responsible for delivering this document to its intended recipient, you are herewith notified that any dissemination, distribution, copying or retention of this document
or the informa tion contained her ein is strictly prohibited. If you have received this document in error, please notify us at service@un ivser aleas.c om i mmediately and permanentl y delete or/and destroy the original and any copy or
printout thereof.
7.2 BASIC EQUIPMENT REQUIRED
(A) PC with Windows XP, V ista or 7 operating system or later and 1 free USB 2.0 port.
(B) Hardware key with USB Cable and twisted „phone" cable with RJ14 + RJ12
connectors or eComm with cross UTP patch cable, power supply and twisted „phone"
cable with RJ14 + RJ12 connectors.
(C) Antennas.
(D) RF Hard tag or RF sticker label.
(E) Power supply for electronic board (HW:N:6163, REV.8.3; SW:V3.4).
(F) 4 screws (8mm or 10mm diameter, at least 60mm long) for each antenna, not
included with system.
(G) Washer and plastic screw anchor (unless using a hardening agent) for each screw.
(H) 4mm Allen (hexagon) wrench for antenna screws.
7.3 CONFIGURATION
(A) Consult section 6.5 and inspect the environment to decide on the best configuration
of antennas. Several configurations may need to be tested before finding the most
suitable one.
7.4 CONNECTION
(A) Connect the power supply to the electronic board (HW:N:6163, REV.8.3; SW:V3.4)
marked in the Pic. 1 - El. board description.
(B) Interconnect the hardware key to the electronic board (HW:N:6163, REV.8.3;
SW:V3.4) and the PC.
(C) Plug in the power supply to the mains supply. Open the RF Application software.
7.5 APPLICATION SETTINGS
(A) In "Alarm" page verify that correct alarms and jammers are turned on, so that the
system alarms will go off correctly when they are tested.