User manual

Page 66 Setup – PAT700 Total Organic Carbon Analyzer
Operator Manual Anatel
5.7 Printer
The printer icon allows you to configure the printer settings for the analyzer. You can
independently configure the printing of analysis results and the frequency of printing for online
TOC and conductivity modes.
Printer connection is made using the 9-pin D-subminiature serial port. The RS-232 interface
communicates at 9600 baud, 8 data bits, 1 stop bit, no parity.
The printout report requires a 40-column printer.
• If the printer is purchased from Hach, the switches are preset at the factory.
• If a Seiko Instruments DPU-414 Type II thermal printer is installed, the electronic DIP
switches must be set as listed in Table 5-2:
Table 5-2 Printer DIP switch settings
DIP Switch 1
Switch Setting Function
1 Off Serial input
2 On High print speed
3 On Auto loading enabled
4 Off Auto linefeed disabled
5 On Enabled setting
6 Off Print density
7 On Print density
8 On Print density
DIP Switch 2
Switch Setting Function
1 On 40-column printing
2 On Backup font enabled
3 On Normal characters
4OffZero = Slash
5 On International character set = USA
6 On International character set = USA
7 On International character set = USA
8 Off International character set = USA