Installation Guide
The yellow wire is used only for interconnect (multiple station operations) USI Electric or
Universal model alarms. Connecting this yellow wire to any other circuits may result in
damage and alarm malfunction. All interconnect alarms must be powered from a single circuit.
If local codes do not specify, be sure the neutral wire is common to all alarms. The maximum
wire run distance between the rst and last alarm/device in an interconnected system is
1,000 feet. NOTE: Use standard household wire, 18 gauge or larger, rated at least 300V, as
required by local codes. This wire is commonly available at most electrical supply and
hardware stores. The resistance of the interconnect wiring shall be a maximum of 10 Ohms.
The alarm wiring shall be in accordance with the provisions of Articles 210 and 300.3(B) of
the National Electrical Code, ANSI/NFPA 70. According to the NFPA 72 / Ed. 2013; paragraph
29.6.3 Household Fire Alarm Systems /AC Primary Power Source: “AC primary (main)
power shall be supplied either from a dedicated branch circuit or the un-switched portion
of a branch circuit also used for power and lighting.”
2. Attach the mounting bracket to the electrical junction box.
3. To activate 9 volt battery and alarm, hold the QUICK DRAW
(R)
battery drawer closed, pull and
remove the PULL-TAB. Conrm that the entire PULL-TAB has been completely removed. Discard
PULL-TAB.
4. Plug the AC QUICK CONNECTOR into the alarm base. Push and twist the alarm clockwise onto
the mounting bracket.
5. See “OPTIONAL TAMPER RESISTANT FEATURES” and “TO ACTIVATE THE LOCKING
FEATURES” instructions on Page 4.
6. Turn on AC power and check the LED’s for proper operation. The green LED should be on to
indicate AC power. The red LED blinks on once approx. every 40 seconds to indicate proper
operation.
Page 7
IMPORTANT!
The battery backup is designed to provide short-term emergency power to the CO and Natural Gas
Alarm. Actual backup time depends on the strength (freshness) of the battery. The battery backup
will not work unless a good battery is properly installed.
When the alarm utilizes battery backup power, the natural gas sensor will operate the alarm and will
sample less frequently to extend battery life. Natural gas could be present during this period between
samples without the alarm sounding, especially if there is a rapid buildup of natural gas.
NOTE: It is best to “reset” the alarms before initial test is performed. See Page 9 for Reset
procedures.
120 VAC 60Hz
100mA Max.
OPERATION, TESTING & MAINTENANCE
OPERATION: The alarm is operating once the AC power is connected and turned on.
READY/ACTIVE CONDITION: The green LED is on and blinks off once approx. every 20 seconds
to indicate the alarm is properly functioning.
GREEN LED: The green LED is off and blinks on approx. every 40 seconds whenever AC power
is turned off.
CO ALARM: The alarm signal is 4 beeps, 5 second pause, repeat. The red LED blinks on in sync
with the cycle of 4 beeps.
GAS ALARM: The alarm signal is 1 beep, 2 second pause, repeat. The blue LED blinks on in
sync with the horn beep.
NUISANCE ALARM: If the horn signals and the red or blue LED’s blink on for no apparent reason
and no obvious hazard is present, please verify that the alarm is mounted in the correct location.
Reset the alarm as instructed in the Operational Summary.
CO ALARM LATCHING LED INDICATOR: The alarm had previously detected CO and had alarmed.
The red LED is off and blinks on approx. every 5 seconds until reset. Follow the reset instructions
to remove the latching LED.