Owner`s manual
Page 2
ZR-1N Z REPEATER
ZR-1N Front and Side Panel Descriptions
The front panel consists of 3 indicator lights which will illuminate
when in use.
Power LED: Indicates that the ZR-1N is powered on when illuminated.
Status LED: The LED will show what the RF signal strength of the
ZR-1N to the MRX-10. By pressing the TEST button on the side of
the unit, it will indicate the signal strength. When the LED is:
. OFF: The ZR-1N is not testing for signal strength, and the TEST
button should be pressed.
. Orange: The signal strength is LOW, and the ZR-1N should be
move to a different location
. Green: The signal strength is GOOD, and the ZR-1N is in a
good location.
Data LED: The LED will flash RED when the unit is transmitting or
receiving data.
Antenna: Omnidirectional antenna. Adjust the antenna for best per-
formance. Usually vertical positioning works well.
DC9V Power: Attach the included 9V DC power supply here.
Mounting Plate: May be attached to a wall or other surface with the
included screws for easy slide on/off mounting.
POWER
LED
STATUS
LED
USB
DC9V
Power
TEST
Mounting
Plate
Antenna
DATA
LED