Specifications

Universal RCP – Operation Manual
V3.1
Page 4
22/12/11
Menu Structure
At the end of this manual there are flow charts showing the four main menu trees. These can be used as a
‘quick reference’ to see what menus are available, although for the ‘Main’ and ‘Eng’ menus it will depend
on the camera make and model selected, as to which menus are available.
The Menu shown here will always be described as the ‘Home
Menu’.
It can be reached from anywhere else in the menu structure by
holding the Left Hand Menu Select button for a couple of
seconds. (If the Left Menu button is just pressed briefly then it will
simply step back one menu.)
Note that the four Function Adjust buttons are all lit as they all
perform a function, whereas the Menu Select buttons are not lit
and will not have any effect if pressed.
The top row of the display will usually show the make and model of the camera being controlled. (This will
change as different Channel buttons are selected if they have different camera types allocated to them.)
The second row displays the Channel selected and the ID no. associated with that channel. (ID nos. can
be different to channel nos. for various reasons described later.)
The third row will usually describe the function being adjusted by the Function Adjust buttons as shown in
later menu descriptions.
Finally, the fourth row will show the values of the items being adjusted.
Setup Menus
Pressing the right hand Function Adjust button from the Main Menu
will take you into the Password Menu required for accessing the
main setup functions of the system. A Password protected menu is
required to access and change any of the functions which might be
considered ‘fatal’ to the operation of the system if changed by
somebody who does not fully understand the implications of
changes to these settings!
The Password is entered using the Channel Select buttons, and the
actual password is provided when purchasing an RCP.
When the correct password is successfully entered the camera
selection screen is displayed as shown here.
The two left hand Function Adjust buttons can be used to step up
and down through the available camera manufacturers. When the
correct manufacturer is found, the two right hand Function Adjust
buttons are used to select a particular camera model.
Note that the camera make/model selection can be different for
each of the six channel buttons.
MENU
SELECT
FUNCTION ADJUST
H i t a c h i D K – H 3 2
C h a n n e l 1 I D 1
M e n u S e l e c t i o n
M a i n E n g A u x S e t u p
MENU
SELECT
FUNCTION ADJUST
C A M E R A T Y P E
C h a n n e l 1 I D 1
M a k e M o d e l
H i t a c h i D K – H 3 2
MENU
SELECT
FUNCTION ADJUST
M A S T E R S E T U P
E n t e r P a s s w o r d ?
* * * *

*
