Specifications

Universal RCP – Operation Manual
V3.1
Page 20
22/12/11
Sony Q-Ball IR
Channel 1 ID 1
Menu Selection
Main Eng Aux Setup
Sony Q-Ball IR
Channel 1 ID 1
PTZF Wipe Wash Sw1
Sony Q-Ball IR
Channel 1 ID 1
Iris Foc Mono
Sw2 Norm Man Off
Sony Q-Ball IR
Channel 1 ID 1
Stab Frz Neg Pwr
Off Off Off On
RCP Panel - Aux Menus
This main menu select screen can be reached at any time by
repeated presses of the top left menu button. Note that if a
‘menu’ or ‘function’ button is illuminated it will perform some
action. If unlit it will have no effect.
This screen allows some basic switch
functions to be transmitted to the
Interface Box. Also, it is possible to
enter the Pan, Tilt, Zoom and Focus
menus from here
Sw2 sends a switch function to the Interface Box.
The Iris button is to allow changing the direction
of movement when a DC Iris motor is fitted to the
lens. Focus switches between Manual or Auto if
the lens allows it. Mono sets the camera to a
monochrome picture if the camera has that
function.
The Stab switch sets lens stabilisation on if
possible. Freeze will freeze the picture if
possible, and Neg will set the picture to negative
if the camera has that function. Power will
switch camera power on and off if that facility is
available.
Sony Q-Ball IR
Channel 1 ID 1
Use knobs to adjust
PAN TILT
This screen allows a pan and tilt head to be
moved if being used. Adjustment is done
by using the Colour control knobs. By
pressing the button between the knobs the
screen changes to allow adjustment of the
lens Zoom and Focus. The next menu
selected will depend on which of these two
screens is being used.
PAN ENDSTOPS
Channel 1 ID 1
Off Enable
TILT ENDSTOPS
Channel 1 ID 1
Off Enable
ZOOM DRIFT ADJUST
Channel 1 ID 1
Reset Inc Dec
FOCUS OFFSET ADJUST
Channel 1 ID 1
Reset Inc Dec
The Pan and Tilt endstops can only be set for certain types of head. The ‘Off’ button may
either clear just the pan or tilt endstops, clear both pan and tilt endstops, or remove the
endstops completely depending on the type of head. To set the endstops press ‘Enable’ and
then follow the instructions setting first one endstop and then the other.
This screen allows zoom drift to be
corrected if there is a small drift that
cannot be corrected any other way. Always
do a reset before adjusting.
This screen allows focus offset if
problems are experienced reaching
infinity focus. Always do a reset before
adjusting.
Sony Q-Ball IR
Channel 1 ID 1
Hflip Vflip
Off Off
H flip will reverse the picture horizontally and
V flip will reverse it vertically on cameras that
have this function.