Specifications

Universal RCP – Operation Manual
V3.1
Page 19
22/12/11
Hitachi DK-H100
Channel 1 ID 1
Menu Selection
Main Eng Aux Setup
Hitachi DK-H100
Channel 1 ID 1
Det Band Wht Clip
Norm 103%
Store Recall
Hitachi DK-H100
Channel 1 ID 1
H Detail V Detail
8 8
RCP Panel - Eng Menus
This main menu select screen can be reached at any time by
holding down the top left menu button. Note that if a ‘menu’ or
‘function’ button is illuminated it will perform some action. If
unlit it will have no effect. Note that not all menus shown here
will appear for all camera models. Only those allowed by the
Manufacturer will be shown.
Sets H & V Detail values. Note that
more settings for detail can usually be
found in the On Screen Display
Menus.
Detail Band sets the operating frequency
of the contour correction. White Clip
will set the maximum video output
level.
Hitachi DK-H100
Channel 1 ID 1
Aspect Format
16x9 1080i/50
Store Recall
Hitachi DK-H100
Channel 1 ID 1
Fine Phase
106 154
Store Recall
Hitachi DK-H100
Channel 1 ID 1
H Phase ColPhase
127 180
H Phase sets the line timing when
using Genlock. Colour Phase sets 0,
90, 180, or 270 coarse values.
Fine Phase sets the fine setting of the
colour phase when using Genlock.
Aspect sets either 4x3 or 16x9 if
allowed by the camera model. Format
will switch the camera video format
where available.
Hitachi DK-H100
Channel 1 ID 1
ABS/REL Auto Setup
High Res Start
Store Recall
Absolute or Relative sets the type of
control for some parameters of the
camera. Absolute will send fixed
values to the camera while Relative
will send increasing or decreasing
values. Relative can be useful when
using multiple RCP’s.
Hitachi DK-H100
Channel 1 ID 1
Iris Mode Masking
Normal ITU-709
Iris Mode will usually be set to
‘Normal’. Other settings may be used
in the future for some 3D setups.
Masking selects the type of Matrix or
Masking values selected in the camera.