Specifications

Universal RCP – Operation Manual
V3.1
Page 16
22/12/11
ADDENDUM
There are a number of ‘special’ features which can be accessed which have not been described above.
These can be accessed by holding down the ‘Auto’ button and then pressing one of the channel buttons to
perform the action.
AUTO + Channel 1 button:-
This displays the serial no. of the RCP.
AUTO + Channel 2 button:-
When upgrading from the standard RCP to the 3D version you will need to enter a code to activate the 3D
modes. Pressing AUTO + Channel 2 button will show a screen on which to enter the activation code.
Once activated the 3D modes will stay permanently available.
AUTO + Channel 3 button:-
This action will toggle the requirement for a password when accessing the ‘Setup’ functions. Not having
the password feature enables much faster setting up of multiple cameras. Once setup, the password
feature should be re-enabled if the RCP is being operated by somebody who does not fully understand
the system!
AUTO + Channel 4 button:-
This feature makes it possible to disable some of the ‘Action’ buttons to prevent inadvertent operation.
The action will toggle the buttons between enabled and disabled. The buttons affected are – White Bal,
Black Bal, OSD and Bars.
The ‘Update Camera’ and ‘Test Cue’ buttons are left unaffected as they will generally not cause a change
in the picture.
Resetting the RCP memory:-
In the unlikely event of a major software crash it is possible to do a ‘factory reset’ of the RCP internal
software memories. To do this simply hold down the two ‘Menu Select’ buttons above the LCD at the
same time as pressing the Reset button (on the side of the PCB), or switching on power to the unit.
Release the buttons when you see a display counting up as the memories are reset.