Specifications

Universal RCP – Operation Manual
V3.1
Page 9
22/12/11
Aux Menus
The Aux menus are accessed by pressing the third function button from the left while the Home menu is
displayed.
These Aux menus provide access to switch functions such as Wash, Wipe etc and the Pan, Tilt, Zoom
and Focus controls for adjusting a remote head if it is being used.
These Menus are the same for all camera types with functions that are not available for a particular
camera appearing blank
The first Aux menu provides access to the PTZF (Pan, Tilt, Zoom,
Focus) controls.
Also, single function button presses here will operate remote
Wipe, Wash and switch functions. These will only be available on
certain types of remote head, usually the weatherproof housing
systems.
After selecting PTZF, the screen shown here is displayed saying
‘Use knobs to Adjust’.
The red knob will then adjust the Pan, and the Blue knob will
adjust the Tilt, assuming there is a pan and tilt head connected and on the selected ID number.
Pressing the Gain/Black button will change the display to show
‘Zoom and Focus’. These can now be adjusted using the same red
or blue knobs.
Note that when controlling the colours, the Gain/Black function will
default back to Gains after a preset time, here the Zoom and Focus
selection remains until either the button is pressed again to return
to Pan and Tilt, or the menu is exited using the left hand Menu
Select button.
During PTZF operation the Master Black and Iris controls continue
to function normally.
Pressing the right hand Menu Select button will move on to a new
menu which will be dependent on whether Pan and Tilt or Zoom
and Focus was selected.
If Pan/Tilt was selected then there are two further menus which are used to set the Pan and Tilt endstops.
This can be useful if there is no operator at the Joystick position and the endstops need to be set or
disabled for some reason.
From the Zoom and Focus menu, there are also two further menus which can be accessed. These are for
Zoom Drift adjustment and Focus Offset adjustment.
Moving back to the first Aux Menu (PTZF, Wipe, Wash, etc.), pressing the right hand Menu Select button
from here takes you further into the Aux Menus.
SW2 is another button which can activate a remote switch function at the interface box.
MENU
SELECT
FUNCTION ADJUST
H i t a c h i D K – H 3 2
C h a n n e l 1 I D 1
PTZF Wipe Wash SW1
MENU
SELECT
FUNCTION ADJUST
H i t a c h i D K – H 3 2
C h a n n e l 1 I D 1
U s e K n o b s t o A d j u s t
P A N T I L T
GAIN / BLACK