Operating instructions

Part 3 - Remote Setup
27
Streaming
• Primary/Secondary/Tertiary: Multistreaming
is supported. (priority: Primary > Secondary >
Tertiary). Enable/disable streaming use. The lower
stream settings may change depending on higher
stream settings. The tertiary and quaternary streams
may not be available depending on higher stream
settings (refer to the table below).
Primary Secondary Tertiary
Resolution ips Resolution ips Resolution ips
1920x1080 30 704x480 30 - -
• Compression: Choose the streaming compression
method.
• Resolution: Choose a resolution setting for video
streaming. The current stream resolution cannot be
higher than the higher stream resolution.
• Quality: Choose a quality setting for video
streaming.
• Bitrate Control: Choose a bitrate control mode for
H.264 compression.
- CBR (Fixed Bitrate): Maintains the current
bitrate regardless of motion change in the video.
- VBR (Variable Bitrate): Bitrate varies depending
on motion changes in the video. Less movement
places less load on the network and takes up less
storage space.
• Frame Rate: Choose a frame rate setting for video
streaming. The fame rate of the current stream
cannot be higher than the fame rate of the higher
stream if those stream resolutions are same.
• Default Record Stream: Choose a stream to use
for recording. This setting, however, may not apply
if a recording stream has been designated from the
remote program.
• Multi-View Streaming: Designate a specific area
of the screen and stream images from that area
only. (not supported for the primary stream) Click
Setup to designate a streaming area.
Select On and then specify the streaming area's
resolution.
- Resolution Limit: Indicates the maximum
resolution that can be set for the streaming area.
- Resolution: Designate a streaming area.
Designated area is marked in red on the screen.
You can adjust the resolution of the area or
reposition the area by dragging and dropping
using the mouse.
- Current Resolution: Displays the resolution of
the designated streaming area.
If multiple users are connected to the camera, the
increase in bandwidth use can lower the frame rate.