Operating instructions

Part 1 – Introduction
11
• Check your local laws and regulations on making
video or audio recordings. The user will be held
liable for any violation of the law. (Article 25-5 of
the Personal Information Protection Act: Operators
of image data processing devices may not
operate such devices for purposes other than as
originally intended during device installation, place
such devices at locations other than as originally
intended, or use such devices to record audio.)
• When switching over from 12 VDC to PoE as the
power source, the system will be rebooted once
the power adapter is disconnected.
• Organize the power cable so that it will not cause
people to trip over or become damaged from
chairs, cabinets, desks, and other objects in the
vicinity. Do not run the power cable underneath
carpet or a rug or plug the cable into a power
outlet shared by a number of other devices.
Factory Reset
This will only be performed remotely on the rare
occasions that you want to return all settings to the
original factory settings. Refer to the IDIS Discovery
operation manual for details on remote factory
resetting.
A factory reset will clear all camera settings
configured by the user.
Installation
Installation of this product does not require the use of
special tools.
For more information on other devices comprising the
overall system, refer to their respective installation
manuals.
Product color and design may vary depending on
the model.
Installation
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
1
Screw the camera sun shield to the camera using
screws provided with the camera.
2
Screw the mounting bracket to the wall or ceiling
by using screws provided with the camera.
3
Screw the bottom cover to the mounting bracket
by using screws provided with the camera.
4
Connect external devices, network and power adapter.
5
Apply power.
Dimensions
322.7mm (12.70”)
90.5mm (3.56”)