Owner`s manual

WC-1 WIRELESS CONTROLLER
Page 8
Overview of IR Routing
There are several considerations to take into account when you are
installing an WC-1 to control an array of components:
1. When connecting a flasher from the WC-1 to your component
make sure to notate the IR outputs being used. Program the same
port designations into the ccGEN2 program.
2. Assigning each component with its own individualized port
number helps to control multiple components eliminating inter-
ference.
3. Identical components must receive IR commands ONLY from a
dedicated flasher affixed to its front panel or a rear panel direct
IR input.
WC-1
Router