Installation manual

2.3 Remote Control Receptacle

The optional remote control receptacle provides a basic operational control interface to the WC 1

controller. The following is the pin-out and control function for the 9 pin receptacle.

PIN DESCRIPTION

1 +24 vdc @ 100 ma. Power Output

2 ESTOP – 24 VDC input

3 CYCLE START – 24 VDC input

4 INC – 24 VDC Input. Increase the current during the weld cycle

5 DEC – 24 VDC Input. Decreases the current during the weld cycle

6 CYCLE ON - 24 VDC Active low sinking (Pull-Down) output

7 CYCLE COMPLETE – 24 VDC Active Low sinking (Pull-Down) output

8 EARTH GROUND

9 READY – 24 vdc Active Low sinking (Pull-Down) output

Table 1 - WC 1 Remote Control Receptacle Pin-Out