Owner`s manual

Page | 17
Whattoknowbeforeyoustart:
● You can program up to 20 sequential
commands on a Macro button.
● You can program delays in between
commands by pressing the [PAUSE]
button on the transport control.
- Each press adds a one-half second
delay.
- If you add the delay time as the first
step of Macro commands, the remote
will not send the Macro unless the
button is held for two seconds.
● You can set up program macro
commands in layers by pressing the
[STOP] button in between commands.
This will allow you to rotate commands,
and is typically used to program channel
lists. For example, when working the
“My Favorites” button, if you press
[009], [STOP], [035], [STOP], [365],
[STOP] the remote will send out 009 at
the first press of the selected [My
Favorites] button, and then send out 035
at the second press, etc.
● You cannot set-up the [CH ▲▼] or
[PAUSE ║] buttons with macros.