User`s guide

TROUBLESHOOTING (continued)
PROBLEM: DVD/VCR Combo does not respond
properly.
SOLUTION: Use the VCR codes for your brand.Some
combo units may require both a DVD
code and a VCR code for full operation.
PROBLEM: Changing channels does not work
properly.
SOLUTION: If the original remote control required
pressing ENTER to change channels,
then press
ENTER on the remote control
after entering the channel number.
PROBLEM: Tried Search For Your Code method and
still could not find a working code.
SOLUTION: Clear the device key as follows:Press and
hold
SET until the LED (red light) blinks
twice,then release.Next enter
9- 9 - 2.
Then press the device key to be cleared
twice.Now repeat the Search For Your
Code method on page 11.
PROBLEM: Remote control does not turn on Sony or
Sharp TV/VCR Combo.
SOLUTION: For power on,these products require
programming TV codes.For Sony, use
TV code 0000 and VCR code 0032.For
Sharp,use TV code 0093 and VCR code
0048.
PROBLEM:
CH+ and CH- do not work for your
RCA TV.
SOLUTION: Due to RCA design (1983-1987),only the
original remote control will operate these
functions.
PROBLEM: No remote control of volume.
SOLUTION: See Changing Volume Lockon page 16 to
lock/unlock volume.
32
IMPK6VR manual 1.0 2/21/03 5:46 PM Page 32