IMPVE4P manual 1.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 2 TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Features And Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Key Charts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Device Table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Installing Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 3 INTRODUCTION The One For All DVD Expert Universal Remote Control (URC-4041) is designed to remotely operate up to four home entertainment devices and features intuitive and easy-to use buttons to operate a DVD component. Its sophisticated technology will allow you to consolidate your original home entertainment remote controls into one easy-to-use product.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 4 FEATURES AND FUNCTIONS Use the illustration below to locate features on the One For All DVD Expert Universal Remote Control (URC-4041) and then study the Key Charts (on the next two pages) to learn how they function. To find out what type of devices can be controlled by each device key after programming, see the Device Table on page 7.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 5 Key Charts When the LED (red light) blinks, the remote control is working and (after programming) is sending signals. Press DVD/VCR, AUX, CBL/SAT, or TV once to select a desired home entertainment device to control. Also see the Device Table on page 7. Press POWER once to turn on or off the selected device. For master power control, see Programming A Master Power Macro on page 12. Use the keypad (1 ~ 9 and 0) to directly select channels (e.g., 009 or 031).
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 6 FEATURES AND FUNCTIONS Key Charts (continued) Use CH▲ (or CH▼) to select the next higher (or lower) channel. Press MUTE once to turn the sound off or on. In the DVD mode, press REPEAT once to replay a selected chapter (after pressing TITLE - see below). Use VOL▲ (or VOL▼) to raise (or lower) the sound volume. Use SLEEP to set the sleep timer on a selected device if equipped with this feature. Use ANGLE to perform the angle function on your DVD player.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 7 Device Table NOTE: Please refer to the table below when performing the instructions in “Programming Device Control” on page 9.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 8 INSTALLING BATTERIES ❶ ❷ ❷ ❸ 1. On the remote control’s back, push the tab and lift off the battery cover. 2. Obtain two (2) new AAA alkaline batteries. Match the + and – marks on the batteries to the + and – marks in the battery case, then insert the new batteries. 3. Press the battery cover back into place. The tab should click when the cover is locked. 4. Test the remote control by pressing any mode key (e.g., TV).
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 9 PROGRAMMING DEVICE CONTROL The One For All DVD Expert Universal Remote Control is preprogrammed at the factory to operate an RCA TV, a Toshiba DVD player, a Motorola cable box, and a Pioneer audio receiver/amplifier. To control devices other than the default brands, perform the following steps; otherwise skip this section: 1. Turn on a desired device (e.g.,VCR or DVD player) and, if applicable, insert media (e.g., cassette or disc).
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 10 PROGRAMMING DEVICE CONTROL (continued) 5. Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2 through 5 (starting on the previous page), trying each code for your brand until you find one that works. If it still doesn’t work, try Searching For Your Code below. NOTE: If the device does not have a POWER key, press the (Play) key. 6.
IMPVE4P manual 1.0 4. 4/11/03 4:34 PM Page 11 Aim the remote control at the TV and slowly alternate between pressing POWER and TV. Stop when the TV turns off (after pressing POWER). NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first. 5. To lock in the code, press and release SET. The LED will blink twice. 6.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 12 PROGRAMMING A MASTER POWER MACRO In its default state, the POWER key on the One For All DVD Expert Universal Remote Control will individually power your home entertainment devices on or off. However, you can also program a Master Power Macro onto the POWER key that will sequentially turn on or off all the devices with a single key press. Programming The Power Key For The Master Power Macro 1.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 13 Clearing The Master Power Macro 1. Press and hold SET until the LED (red light) blinks twice, then release SET. 2. Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once. 3. Press and hold SET until the LED blinks twice, then release SET. The Master Power Macro is now cleared. USING KEYMOVER The One For All DVD Expert Universal Remote Control includes a Keymover feature that allows you to map (or copy) keys from one mode (i.e.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 14 USING KEYMOVER Programming Keymover (continued) Upon completion of the above procedure, you can now use your One For All DVD Expert Universal Remote Control to control the TV’s volume and mute in the DVD mode, as well as in the TV mode. Restoring Keymoved Keys to Default Settings Restoring A Single Keymoved Key 1. Press a device key that has a keymoved key. 2. Press and hold SET until the LED (red light) blinks twice, then release SET. 3. Enter 9 - 9 - 4.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 15 3. Press DVD/VCR once, then press AUX once. The LED will blink twice. 4. The AUX key is now ready to be set up to control your second DVD player. See Programming Device Control on page 9. To re-assign other device keys to the AUX key, repeat steps 1 through 4 with a sequence from the below chart: NOTE: Only one device can be assigned to an unused device key at a time.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 16 PROGRAMMING FAVORITE CHANNEL SCAN In the DVD/VCR, CBL/SAT, or TV mode, you can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when FAV is pressed (see Using Channel Scan on the previous page). NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV is pressed while in another mode, the remote control will start scanning all channels instead (if applicable to the selected device). 1.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 17 CHANGING VOLUME LOCK The One For All DVD Expert Universal Remote Control is set at the factory for independent volume control of each selected device. However, you may change the Volume Lock setting to Global Volume Lock so that a device’s volume will be locked to one mode (e.g., to control TV volume in all other modes).After that, if desired, you can perform Individual Volume Unlock on a selected device to set its volume control for independent operation.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 18 CHANGING VOLUME LOCK (continued) Unlocking All Volume Control (Restoring Default Setting) NOTE: Performing these instructions will restore independent volume control for all programmed devices (e.g., TV volume control in TV mode, VCR volume in DVD/VCR mode, etc.). 1. On the remote control, press and hold SET until the LED (red light) blinks twice,then release SET. 2. Enter 9 - 9 - 3 and then press VOL ▲ once. The LED will blink four times. 3.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 31 TROUBLESHOOTING PROBLEM: LED (red light) does not blink when you press a key. SOLUTION: Replace batteries with two new AAA alkaline batteries. PROBLEM: LED blinks when you press a key, but home entertainment device does not respond. SOLUTION: Make sure the remote control is aimed at your home entertainment device and is not farther than 15 feet away. PROBLEM: The unit does not control home entertainment devices or commands are not working properly.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 32 INSTRUCTIONS TO THE USER This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide a reasonable protection against harmful interference in a residential installation.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 33 LIFETIME WARRANTY One For ALL ("OFA") warrants this product to be free from defects in materials and workmanship, under normal use, throughout the period of the product’s ownership by the original purchaser.
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 34 ADDITIONAL INFORMATION As you update your home entertainment system, One For All® has a universal remote control that will fit your needs. Look for these exciting products at a retailer near you. One For All Access 3 . . . . . . . . . . . . . . . . . . . . . URC-3605 One For All Big Easy 3-Device. . . . . . . . . . . . . URC-3300 One For All DVD Expert 4-Device . . . . . . . . . URC-4041 One For All Big Easy 4-Device. . . . . . . . . . . . .
IMPVE4P manual 1.
IMPVE4P manual 1.
