Installation guide

PROGRAMMING
NUMBER OF PRESSES RF (IN MHZ) BRAND
1 310, 315, et 390 LiftMaster
®
with Yellow LEARN button
2 315 LiftMaster
®
with Purple LEARN button
3 390 LiftMaster
®
with Orange LEARN button
4 390 LiftMaster
®
with Green LEARN button
5 315 Genie
®
/Overhead Door
®
Intellicode
6 390 Genie
®
/Overhead Door
®
Intellicode
7 318 Linear
®
Mega Code
8 310 Stanley
®
Secure Code
9 372.5 Wayne Dalton
®
Keeloq
If programming an additional door sensor and garage door opener for a second door, repeat the programming steps using BUTTON 2 instead of BUTTON 1.
PROGRAM THE WI-FI HUB TO THE GARAGE DOOR OPENER
2
1
Press and release the BUTTON (Settings), the Blue LED will turn on
solid.
2
Press and hold the BUTTON again until the green and yellow LEDs
alternate blinking. Press and release the
BUTTON again, the yellow LED
will turn on solid.
3
Press and release BUTTON 1 the number of times indicated in
the chart (the yellow LED will turn on solid):
4
Press and release the BUTTON. The yellow and green LEDs will blink.
5
Press and release the LEARN button on the garage door opener. Your
garage door opener may look different.
6
Press and release BUTTON 1 until the garage door opener clicks. Press
and release BUTTON 1 again to activate the garage door opener.
If the garage door opener does not activate, press and release the
BUTTON, then repeat steps 3-6.
7
To exit programming mode, press and hold the BUTTON until the blue
LED blinks.
Blue LED (ON)
BUTTON
Green and yellow
LEDs
press and release...
LEARN
button
PROGRAM THE DOOR SENSOR TO THE WI-FI HUB
1
1
3
Plug in the Wi-Fi Hub. The blue LED will
blink.
Press and release the Test button on the door
sensor until the Wi-Fi hub beeps and the light
fl ashes. The yellow LED on the
Wi-Fi hub will turn off.
2
Press and release BUTTON 1 on the Wi-Fi
hub. The yellow LED will turn on solid.
Blue LED (blink)
“BEEP”
press and release
press and release until....
BUTTON 1
BUTTON
BUTTON
Yellow LED (ON)