Owner's Manual

4
Installation:
The TKP-5600 is wall mountable and fits into a standard one-gang opening.
Prior to installation, make sure power is available at the preferred location.
Power can be supplied to the TKP-5600 through an Ethernet (RJ45) cable connected to a
PoE (Power over Ethernet) in either of the following ways:
● Router/Switch
● PoE Injector
Power over Ethernet describes a system that passes electrical power safely, along with
data, along Ethernet cabling. A shielded Ethernet cable is preferred. The IEEE standard
for PoE requires a Category 5 or higher for high power levels.
Wall Mounting:
Follow the steps below for installation:
1. Assure the one-gang opening is fitted with the standard one-gang
retro-box (available at almost any electronic supplier).
2. Mount the wall-plate to the two-gang retro-box.
3. Connect the Ethernet cable to the rear of the supplied TKP-5600.
4. The TKP-5600 easily snaps into the wall-plate.
The keypad mount rotates to accommodate landscape or portrait viewing modes. The
viewing mode is set from within the Accelerator 2.0 software.
One-Gang Box
Portrait
Landscape