Owner`s manual

Other |n orma iQn
Noisy stereo reception
May b_* a w_*ak station. Use ,5'oftrld m_*nu to choose mono sound.
No picture, no sound but TV is on
Maybe the cable/air fhnction is set to the wrong position. Go to page, _37 for detailed instructions.
The channel might be blank -- change channels.
if you're watching your VCR and it's connected witl_ coaxial cable to the CABLE/ANTENNA jack, tune the TV to channel 3 or 4
(whichever channel is selected on the 3/4 switch on the back of your VCR). Also check to make sure the TV/VCR button on the VCR
is in the correct mode (press the TV/VCR button on your VCIO.
Sound okay, picture poor
Check antenna connections. Make sure all of the cables an, firmly connected to the jacks.
TW adjusting sharpness function to improve weak signals. Go to page 35 for more instructions.
Volume buttons not adjusting volume louder
Check to make sure volmne isn't limited by the maximmn volume fkature. Go to page 37 for more instructions.
Picture not moving
You have activaWd the Preezc feature by pressing FREEZE or OK on the remote. Press any button to 'unfreeze' the picture.
Black box appears on the screen
Closed-captioning might be on. Check Ch)sed (2q)tiorl in the Setup menu. Go to page' 38 for more instructions.
Freeze not working
The flceze fkature is not available for Component video (CMPI or CMP2) or DVI inputs.
Low battery warning appears on screen
Place n_*w batteries in remote.
TV picture keeps switching between screen formats abruptly
Switch the Auto,format feature to O,ff_ See page 34 for more in_)rmation.
The Remote Control Doesn't Work
Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
Maybe the remote isn't aimed directly at the component (TV, VCR, DVD player, etc.) that you're twing to operate.
Maybe remote is not in 'IV Mode. Press the 'IV button so remote will control 'IV.
Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote. (Note, if you remove the
batteries, you may have to reprogram the remote to operate other components.)
You might need to drain the remote's microprocessor: remove baneries and press the number I button for at least 60 seconds.
Rdease the 1 button, replace the batteries, and (if necessm T) program the remote again.
Make sure there's nothing plugged into the WIRED IR jack on the TV's back panel. The remote that came with your 'IV won't work if
anything is plugged into this jack.
Problems with V-Chip/Parental Controls
The rating limits don't work
You nmst lock the svttings. Go to thv MAIN MEN_) (pwss MENU on your wmotv), svlvct Parental (2mtrol, svlvct Lock Parental
(2mtrols.
I don't remember my password and I want to unlock the TV
if you forget your password, press MENU, then select Pare_ltal Cor_trol (the password cnt W screen appears). Sinmltaneously press
and hold CH+ and VOL+ on the TV's front panvl for 8 seconds. The Parental control menu appvars on thv screvn, and you can rv-
enter a password via Lock Parer_tal (2mtrols.
The V=Chip won't let me watch a program even though it's not rated as violent.
Maybe the movie was given an NR (Not Rated) status. Afl_,r you block movie ratings you must set NR to View separat_,ly in order to
view movies with an NR rating.
40 Graphics contained within this publication are fi)r tepresentation only. Chapter 5