Specifications

42” HD Gas Plasma Display Rosen Aviation Displays, LLC
7
Operator Interface Connections
All operator connectors are located at the rear of the unit. Only one video source is
required for your new 42" HD gas plasma display. However, multiple video sources can be
connected at the same time.
Figure 2
Up to 8 Video Inputs:
INPUT CONNECTOR
TYPE
DESCRIPTION BANDWIDTH
DVI DVI 1.0 Computer Digital RGB Up to 60Hz 768p
RGB DVI 1.0/HDB15 Computer RGB or DTV/HDTV
Component
Up to 60Hz 768p
YPbPr 3 BNCs DTV/HDTV Component Up to 60Hz 768p or
30Hz 1080i
S-Video DIN4 NTSC/PAL Baseband Interlaced STV
S-Video A (*) DIN4 NTSC/PAL Baseband Interlaced STV
Composite (* and **) RCA NTSC/PAL Baseband Interlaced STV
Composite (* and **) RCA NTSC/PAL Baseband Interlaced STV
Composite (* and **) RCA NTSC/PAL Baseband Interlaced STV
NOTE: A Source cannot be selected from the OSD unless it has been enabled.
See Input Port Enable on page 16.
* With Video Bundle Accessory
** Three composite inputs can be replaced by one component input with interlaced STV bandwidth.
Note: When connecting a video source to the display unit, keep in mind that a higher quality cable will
result in better picture quality.
Ground Stud
Fuse Carrier
IR Code Switch
Video Bundle