Specifications

42” HD Gas Plasma Display Rosen Aviation Displays, LLC
6
Installation and Connection
Installation Warnings
The display unit shall be handled by at least two persons during installation and moving.
The display should be operated only when proper connection has been made to the
grounding stud provided on the unit.
Mounting the unit in any orientation with installer/user supplied mounting hardware is totally
the installer/user’s responsibility and liability.
Removal of the front bezel is strictly prohibited.
Exposure of the product to corrosive environments including ocean spray, rain or moisture,
or allowing water or other liquids to enter the unit shall void warranty.
Installation of the 42" HD gas plasma display into any aviation or mobile application must
be as specified in the applicable installation drawings. Any provided applicable addenda to
this manual for installation and/or maintenance must also be followed.
The display is cooled using air vents. Air vents must be open to free air in order to function
properly. The display must be installed with at least 1 inch of clearance above and below
the unit.
Failure to observe the safety configuration of the product and handle accordingly shall void
warranty.