Specifications
42” HD Gas Plasma Display Rosen Aviation Displays, LLC
25
APPENDIX B: REMOTE CONTROL OPERATION OVERVIEW
Rosen Aviation Displays, LLC, 42" HD Gas Plasma Display Technical Manual
Menus and RS232 Commands for the HD Digital Video Controller
General Description
The extensive menu and RS232 control system that has been built into the HD digital video
controller (HD DVC) has been designed for simple navigation, user friendliness, and
application diversity. At the same time, it provides the most exhaustive submenu system
available for application fine-tuning of the displayed video signal. Menus are described in
full detail in Appendix C (page 30).
To bring up the menu system, press MENU on the remote control while in the TV mode. To
move through the menus, use the up arrow (pause), right arrow (FF), left arrow (REW),
and the down arrow (STOP) on the remote. To turn the menu off, either wait for the time
out or press MENU again.
Menus will appear similar to those stated below, however once sources are connected and
the application varies the settings, these menus might appear slightly different. These
differences will be noted throughout the text of this document.
Definitions
• Menu selections with an arrow to their right only will take you to a lower level menu;
excluding the Restore Factory Settings selection
• The icon that resembles a sun indicates brightness options
• The icon that resembles a moon indicates contrast options
• Hue is the tint of the colors on the displayed input
• Color is defined as the amount of the displayed video’s color saturation
NOTE: No settings are saved until SAVE is manually selected from within the
menu. If settings are changed and not saved, the next power up will return
the unit to it’s previously saved parameters.