Specifications

42” HD Gas Plasma Display Rosen Aviation Displays, LLC
20
APPENDIX A: PACKING FOR SHIPMENT
Rosen Aviation Displays, LLC, 42" HD Gas Plasma Display Technical Manual
Shipping Procedure for 42" HD Gas Plasma Display
In the event that the 42” display needs to be shipped, the following procedures must be
followed to protect it from damage. Rosen Aviation Displays, LLC is NOT Responsible for
damage to equipment not packaged according to the guidelines listed below. Customer is
responsible for freight charges back to the factory for warranty repair. Factory will pay
return freight via ground service.
Note: Save all packaging in case the display must be shipped.
1. Locate the original corrugated shipping container, foam cushions, wooden pallet and
reusable straps. If the original shipping materials are not available, contact Rosen
Aviation Displays, LLC for information regarding the purchase of replacement
shipping packaging.
2. Ensure that the box is on the pallet as shown in Figure A.1.
3. Place bottom foam cushion in sides and bottom of box, noting orientation of notch
as shown in Figure A.1.
4. Wrap the display in the pink polyethylene plastic sheet to protect the painted
surfaces and glass front filter from damage during shipment.
5. Place the wrapped display into the box and insert the other foam cushion over the
top edge of display.
6. Seal the box lid with packaging tape.
7. Secure the outer box to the pallet with two polypropylene straps and buckles as
shown in Figure A.1.
8. Place FRAGILE labels on all four sides and the top of the outer box.