Specifications
42” HD Gas Plasma Display Rosen Aviation Displays, LLC
18
Operator Troubleshooting
Category Symptom Check
Unit does not come on
1. Input power cord connections
2. Rear line fuse
3. Power source
Unit comes on but display
does not light or have
O.S.D.
1. Batteries in remote
2. Remote power on
Remote does not work or
unit will not turn on with
infrared remote control
1. Replace infrared remote control batteries
with new, good batteries and reprogram the
remote
2. Ensure that the infrared sensor on the
display is not blocked
Power
Display turns on with
O.S.D. but does not show
video
1. Enable and save the video input per Input
Port Enable on page 16.
2. Video source
3. Video cables from the video source to the
unit
4. Source selection for the display with the
remote control (Refer to Remote Control
commands)
System doesn’t remember
changed settings
1. No settings are saved until SAVE is
manually selected from within the menu. If
settings are changed and not saved, the
next power up will return the unit to it’s
previously saved parameters.
Picture seems distorted:
circles are not round—
video or RGB modes
1. This is usually caused by selecting modes in
the FlexiScreen menu that don’t maintain
pixel correlation; Select Standard or 4:3
mode to confirm
Picture is too dark or too
light
1. O.S.D. for Brightness control
2. Source for poor quality
Picture has too much or
not enough contrast
1. O.S.D. for Contrast control
2. Source for poor quality
Picture is too high on
screen
1. O.S.D. and remote control for position
Picture is too low on
screen
1. O.S.D. and remote control for position
Picture is too far to the left
of the screen
1. O.S.D. and remote control for position
Picture is too far to the
right of the screen
1. O.S.D. and remote control for position
Picture does not have the
correct height
1. O.S.D. and remote control for correct height
All Modes
Picture does not have the
correct width
1. O.S.D. and remote control for correct width
Video Modes
Pictures are too green or
purple
1. HUE in O.S.D.