Specifications
42” HD Gas Plasma Display Rosen Aviation Displays, LLC
17
Care and Maintenance
Screen Cleaning
The screen can be cleaned using a very mild glass cleaner that is non-abrasive, and a lens
grade tissue for optical surfaces. Do not spray the glass cleaner directly onto the glass.
Spray the glass cleaner onto the tissue, and then clean the glass.
Air Vent Cleaning
All air vents of the display should be inspected periodically for buildup of dust or other
obstructions. Such obstructions can interfere with the proper cooling of the unit causing
reduced performance and reliability. Air vent obstructions can be removed by vacuuming
around the air vents.
Fuses
The unit uses ONLY a 5 x 20mm, 5 Amp, 250V time-delay type fuse with a 1500 Amp
interrupting rating such as Littlefuse® 215005 or equivalent. Replace fuse with same type
and rating only. The fuse is located in a snap-in carrier below the input power receptacle.
See Figure 2 (page 7).
Recommendation for Screen Saver
The plasma display panel in the unit incorporates phosphors. These phosphors could be
damaged by prolonged display of still pictures and/or text. Therefore a screen saver
program should be employed in still picture applications. Such applications especially
include computer graphics. However, we often forget that some video sources such as
DVD players can also put up menus and still pictures and/or text. Therefore, protect
against these situations also.
Caution
Do not allow water or other liquids to enter the unit. This can cause
serious damage to the unit that would be very costly to repair.
Always be sure that the AC power is turned off during cleaning.