Specifications

42” HD Gas Plasma Display Rosen Aviation Displays, LLC
15
program or vice versa. These programs can be swapped or toggled from one to the other
using the remote control system or the IR (remote control: factory default direct IR
command button 8).
Note: Figure 2 (page 7) indicates there are certain exclusions to the multiple
scenario PIPs. For example, 2 video inputs sharing the same switch cannot
be combined in a PIP scenario. Also note that the Flexiscreen settings do not
affect PIP widow images in that the format delivered at the switch input will
be displayed in the PIP window. Therefore, letterbox and widescreen formats
will be displayed as such in PIP, although Flexiscreen factors will be applied
to corresponding inputs on the main display.
Picture by Picture
This is a special PIP mode in which the main picture is shown on the left side of the screen
and the PIP is shown on the right side. This mode is offered to provide an unobstructed
view of the main picture while a PIP is activated.
Saving Settings
If any settings have been changed, you can store the new settings so that the unit will
default to these new settings automatically. This can be performed individually for each
source. If you change any settings, and do not save them, the 42" HD gas plasma display
will revert to the most recently saved settings when the unit is turned off.
Brightness Adjustments
The picture brightness is factory set to the middle of the range. This is normally
satisfactory for most viewing. However you may want to adjust it for your specific
conditions. If the brightness is turned up very high, a washout condition might appear. If
this happens, simply decrease the brightness of the display. The OSD shows a bar and a
value for reference while adjusting.
Contrast Adjustments
The picture contrast is factory set to the middle of the range. This is normally satisfactory
for most viewing. However, you may want to adjust it for your specific conditions. The
OSD shows a bar and a value for reference while adjusting.
Hue Adjustments
The picture hue is factory set to provide the most accurate color reproduction. This is
normally satisfactory for most viewing. However you may want to adjust it for your specific
conditions. The OSD shows a bar and a value for reference while adjusting.
Color Adjustments
The picture color is factory set to give true color representations. This is normally
satisfactory for most viewing. However you may want to adjust it for your specific
conditions. The OSD shows a bar and a value for reference while adjusting.
Display Setup
The display unit has many options that can be changed from the factory default to the user
preferences. The display setup options are detailed on the following page.