Specifications
42” HD Gas Plasma Display Rosen Aviation Displays, LLC
10
Input Power and Ground Connections
Ground Stud Connections
The back of the display has a ground stud that must be connected to an earth ground (see
Figure 2 on page 7). It is the installer’s responsibility to determine the local code for
materials and dimensional requirements for lug size, wire size, length and location of the
earth ground connections in the installation.
AC Power Connections
Place the power cord into the back of the unit. Do not connect the power to your wall plug
at this time.
Operator Controls and Indicators
IR Code Switch
On the back of the unit (see Figure 2 on page 7) is a switch labeled IR CODE that is
located between the video bundle input and IR output. It should be in the full down position
as set at the factory. The IR remote control supplied with your unit has been
preprogrammed to operate the OSD with the switch in this position. If you want to change
IR codes to avoid interference from other IR remote controls, you can select a different
switch setting and reprogram the IR to a different code set. See the information provided
with the IR remote control supplied with your unit for code-set and code-switch settings. For
additional information, refer to Appendix B on page 22.
Infrared Remote Control
The infrared remote control supplied with your new 42" HD gas plasma display is the main
user control for the system. It can access all the capabilities of your display. For full details
including the OSD, see Appendix B (page 22) and Appendix C (page 30). The summary
functions available via remote control are described in the following section on unit
operation.
Remote Infrared Sensor
The remote control infrared sensor is located on the front of the display. As you are looking
at the front of the display, the sensor is located in the lower right hand corner of the frame
as shown in Figure 6. You will obtain the best performance from the remote control if you
aim it at this sensor.
Caution
Ensure that the AC power cord is disconnected from the
AC power source before performing the following steps.