Specifications

42” HD Gas Plasma Display Rosen Aviation Displays, LLC
9
S-Video and S-Video.A
If the display is to be used with a video source that uses the S-Video type of
interconnection, connect the 4-pin mini-DIN connector to this connector location, or to the
video bundle’s S-Video.A 4-pin mini-DIN connection (see video bundle in Figure 5). This
cable should not be longer than necessary.
Figure 5
Composite Video
NOTE: A Source cannot be selected from the OSD unless it has been enabled
and saved. See Input Port Enable on page 16.
If the display is to be used with a standard video source, connect a video quality cable with
a RCA connector via the video bundle to this connector location. An alternative is to
purchase a BNC to Phono (RCA) adapter and use a BNC cable between the video source
and the video bundle.
Note: There are up to 3 composite inputs available to the user via the video bundle.
If any of the composite inputs are used on the video bundle, then the
standard-interlaced TV (STV) component video input will be unavailable to
the user.
Standard-Interlaced TV (STV) Component Video (YPbPr.1)
If the display is to be used with a CAV video source, connect video quality cables with RCA
connectors via the video bundle to this source. An alternative is to purchase BNC to Phono
(RCA) adapters and use BNC cables between the video source and the video bundle.
Note: Y is connected to yellow, Pb is connected to white, and Pr is connected to red.
If the component inputs are used on the video bundle, then the STV
composite video inputs will be unavailable to the user.
Computer Control (RS-232)
This RJ45 connector is for advanced computer control without using the infrared remote
control. All of the remote functions are available through this connector with additional
controls available. Appendix B (page 22) provides full details on the RS-232 remote
control including the cable/connector details.
Interface Options
If your unit was ordered with certain interface options, these may be included as follows:
IR Out: This optional output provides wideband, universal remote control
repeater compatibility.
RF Antenna Input: Not Used.
12VDC Out: Output for certain add-on external options that require 12VDC.