Troubleshooting guide

ENGLISH
34
Using the OSD
CURRENT STATUS DISPLAY
MENU SCREEN
When the AUTO OSD mode is set to ON on the menu screen, this mode shows the status corresponding to each
operation.
• The on-screen display will automatically disappear in several seconds.
• For examples, there are 2 status displays as follows.
󰥒When selecting the desired input source 󰥒When selecting the TEST TONE mode
• This function simplifies the setup procedures.
• The menu screen operation is performed easily with the CURSOR control(▲, ▼, ◀, ▶), OSD and ENTER buttons.
This unit incorporates an OSD(On-screen display) function to provide information about basic operation of this unit and to simplify
the setup procedures.
The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes such as current status
display and menu screen.
■Notes: • Any on-screen display shown on the monitor TV will not be recorded onto VIDEO 1.
• In some countries, this unit allows you to select either NTSC or PAL color system as video format.
If it is different from your video components and video softwares, etc., in the standby mode, press the VIDEO INPUT
SELECTOR button keeping the MEMORY/ENTER button pressed on the front panel, then the video format is changed
to the NTSC or the PAL color system.
However, it is fixed to NTSC color system in other countries.
VIDEO 1(OPTICAL 1)
Input source Signal input
FL C FR
SW
SL
SW 0
SB SR
-------------- --------------
- 0dB +
• The main menu will be shown.
• To turn the menu screen off, press this button.
• In the bottom of the display, “up” stands for the CURSOR
UP(▲) button, “down” for the CURSOR DOWN(▼), “󰥨” for
CURSOR LEFT(◀), “󰥧” for CURSOR RIGHT(▶), “OSD”
for OSD button, “ENTER” for ENTER button.
AUTO
12345
67890
T.TONE
DSP
STEREO
POWER
AUDIO
VCR
SPK SET
ADJUST
M1 M2 M3
AUDIO SEL.
OSD
SETUP
SLEEP
DISPLAY
DIMMER
RETURN
P.SCAN
TUNER CD AUX
VIDEO1VIDEO2 VIDEO3
TAPE
7CH DIR.
+
10
TUNE
PRESET
ENTER
SUBTITLE ZOOM
VOLUME
MUTE
CH SEL. CH/LEVEL
MACRO
DVD CABLE SAT
CD AUX TV
STANDBY
PL PARA.
MENU
UNIVERSAL REMOTE CONTROL
RNC
-
45
OSD
SETUP
MAIN MENU
SPEAKER SETUP
FUNCT ION SELECT
SURROUND MODE
CH LEVEL T R IM
AUTO OSD : ON
ENTER : SEL.
Main menu display
up/down:MOVE
OSD:END
• When the speaker setting is “N”, the test tone of the
corresponding channel is not shown.
• When adjusting each channel level or overall volume, the
volume level display will be shown.
• The test tone display will be shown until the test tone mode is
canceled.
Turn the menu screen on.
1
RD-8108R 2002.11.7 3:35 PM 페이지34