Owner`s manual

SETTING UP FOR TV, VCR, CABLE BOX AND SATELLITE RECEIVER
1. Turn on the device you want to control (TV, VCR,
cable box, satellite receiver etc.).
2. Press and hold SETUP until the LED indicator
lights steadily. Release the SETUP button.
3. Press and release mode button for the device
you want to control. The LED blinks once. Use
AUX1 or AUX2 for CD equipment.
4. Enter the 3 digit Code from the Code List
(separate sheet). The LED turns off after the last
digit entered.
5. Point the remote at the device and press the
POWER button. Your device should turn off.
6. Turn your device on and press CHANNEL+. If
the device responds, setup is complete.
NOTES:
For CD players use the AUX 1 or AUX 2 buttons.
If your TV/VCR/Cable Box/Satellite Receiver does
not respond, try the other codes for your brand. If it still doesn’t
respond, try the Code Search method on page 10.
If the LED blinked rapidly when you entered the code, you
may have entered an invalid code. Recheck the code in the
code list (separate sheet) and try again.
If some buttons do not operate your equipment, try one of the
other codes for your brand.
8
USING AUX TO CONTROL A SECOND TV, VCR, CABLE BOX OR
SATELLITE RECEIVER
The AUX button is normally used to control an audio
component, but it can also be configured to control a second
TV, VCR, cable box or satellite receiver.
1. Turn on the equipment you want to control.
2. Press and hold SETUP until the LED indicator
lights steadily. Release Setup button.
3. Press the AUX1 or AUX2 button.
4. Press and release the mode button that
matches the A/V equipment you want to
control. The LED blinks once.
5. Enter the 3 digit Code from the Code List. The
LED turns off after the last digit entered.
6. Point the remote at your audio component
and press the POWER button. Your audio
component should turn off.
7. Turn your audio component on and press
CHANNEL +. If it responds, setup is complete.
9
DI-000-HCCUR-00A-prnspd 8/9/02, 10:16 AM8