Owner`s manual

INTRODUCTION
Congratulations on your purchase of a Leviton Universal
Remote Control.
Make your lights and appliances go to work for you....
The Remote will control most or all of your video and audio
equipment. But what really sets it apart from other remotes is
that you can also control almost any light or appliance in your
home - even in another room! And it’s easy to set up. Within
minutes, you can be using your Remote to dim the lights, start
brewing a fresh pot of coffee and play your favorite movie!*
Here are just some of the things you can do with your
Remote...
• Control your entire audio/video and lighting setup for the
ultimate Home Theater experience.
•Turn on lights at night to scare away intruders if you hear a
noise.
• Start the coffee from your bedroom when you wake up.
•Turn on your electric blanket before the movie ends, so
you it’s nice and warm when you go to bed.
Use this manual to become familiar with your Remote....
This manual will explain how to set up your Remote to use it
with your existing Audio/Video equipment.
Next it will show you how you can use it to set up a Transceiver
Module and Lamp Module (sold separately) to operate
electrical products in your home.
* Requires Leviton Home Control Modules, sold separately.
5
SETTING THE TV SLEEP TIMER
The Sleep Timer automatically turns off the TV after the time
you set. Press the TV button, then follow the instructions below
to set the Sleep Timer:
1. Press and hold TIMER until the LED indicator
lights steadily. Release the TIMER button.
2. Use the number buttons to enter the sleep time
required (1 to 99 minutes). Minutes less than 10
should be entered as follows:
01, 02, 03...09.
3. Press ENTER to confirm the setting.
NOTE: Take care to leave the remote pointing at the
TV to ensure it turns off the TV at the time you set.
CONTROLLING
MODULES
If you have purchased and installed a Transceiver Module,
you can control it and other modules as follows:
1. Press and release the button with the House
symbol on it.
2. Use the number buttons to enter the Unit
Code number of the chosen module. (You do
not need to enter ‘0’ first for a single digit
number.)
3. Press the appropriate button for the function
you require (refer to next page).
12
DI-000-HCCUR-00A-prnspd 8/9/02, 10:16 AM5