Owner`s manual

FCC CAUTION
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
This equipment generates and uses radio frequency energy,
and if not installed and used properly, that is, in strict
accordance with the manufacturers instructions, it may cause
interference to radio and television reception. It has been
type tested and found to comply with the limits for remote
control devices in accordance with the specifications in Sub-
Parts B and C of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause interference to radio or television
reception, which can be determined by unplugging the
equipment, try to correct the interference by one or more of
the following measures.
• Reorient the antenna of the radio/TV experiencing the
interference.
• Relocate the interface with respect to the radio/TV.
• Move the interface away from the radio/TV.
•Plug the interface into an outlet on a different electrical
circuit from the radio/TV
experiencing the interference.
•If necessary, consult your local Dealer for additional
suggestions.
NOTE: Modifications to any of the components in this kit will
void the user’s authority to operate this equipment.
3
6. Press ENTER to confirm the setting.
CHANGING THE HOUSE CODE:
The Remote is factory programmed to House Code A. In most
cases you will not need to change this unless you are
experiencing interference from a neighboring Home Control
system. Receiver module codes must match the Remote
codes to operate.
1. Press and release the button with the House
symbol on it.
2. Press and hold SETUP until the LED indicator
lights steadily. Release Setup button.
3. Use the number buttons to enter the number
equivalent to the chosen House Code (1=A,
2=B...16=P).
4. Press the ENTER button to confirm the House
Code. The LED turns off.
14
DI-000-HCCUR-00A-prnspd 8/9/02, 10:16 AM3