Owner`s manual

READ THIS FIRST!
SAFETY CONSIDERATIONS
Remember to exercise good common sense when using the
Home Automation features of your Remote - especially when
scheduling unattended devices. There can be some
unexpected consequences if not used with care. For example,
an empty coffee pot can be remotely turned on. If that should
happen, your coffee pot could be damaged from
overheating. If an electric heater is turned on by remote
control while clothing is draped over it, a fire could result. DO
NOT USE the remote for the control of high power heating
appliances such as portable heaters.
WARNING: TO PREVENT ELECTRIC SHOCK HAZARD, DO NOT
EXPOSE ANY PART OF THE HOME AUTOMATION SYSTEM TO RAIN
OR MOISTURE
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
DISASSEMBLE ANY PART OF THE HOME AUTOMATION SYSTEM’S
PLUG-IN MODULES OR CONTROLLERS. NO USER-SERVICEABLE
PARTS ARE INSIDE. IF YOU SPILL LIQUID ON A UNIT, DISCONNECT
THE UNIT FROM THE AC OUTLET TO PREVENT POSSIBLE FIRE OR
SHOCK HAZARD AND CONSULT AUTHORIZED SERVICE
PERSONNEL.
POWERLINE OPERATED EQUIPMENT OR ACCESSORIES
CONNECTED TO ANY OF THESE UNITS SHOULD BEAR THE UL
LISTING OR CSA CERTIFICATION MARK AND SHOULD NOT HAVE
BEEN MODIFIED IN ANY WAY THAT MIGHT DEFEAT THEIR SAFETY
FEATURES.
2
TROUBLESHOOTING
The Transceiver Module doesn’t respond to the remote:
• Check the House Code on the Transceiver Module is set to
‘A’. If you have changed the House Code on the remote
(see p. 14), you must reprogram the House Code on all
modules to match the code on the remote.
•Press the ON/OFF button on the front of the Transceiver to
confirm it operates the equipment connected to it.
The Transceiver Module works, but other modules don’t
respond:
• Check that the Module has the same House Code as the
Transceiver Module. If you have changed the House Code
on the remote (see p. 14), you must reprogram the House
Code on all modules to match the code on the remote.
•Try plugging the Module into a different outlet.
NOTE: When you use an RF Transceiver (such as the HCPRF) to
control Modules, you will be able to control up to 16 Modules.
E.G., when you press 1-6-ON you turn on Module number 16.
The Remote won’t control your Audio/Video equipment, or
doesn’t work at all:
• Use manual controls or the original remote control to
confirm the equipment is working properly.
• Be sure you pressed the device key for the device you
want to control.
• Reenter the code for your A/V product from the code
listings on the separate sheet included.
•Try searching for codes as described on page 10.
• Replace the Remote’s batteries.
15
DI-000-HCCUR-00A-prnspd 8/9/02, 10:16 AM2