Specifications
48
REPLACEMENT STROBE LAMPS by Tomar Electronics
Strobe lamps are high-intensity light sources which use glass and quartz tubing lled with xenon gas to
efciently convert 20 to 50% of the applied electrical energy into optical energy. Similarly, an incandescent light
converts only 1 to 3% of the electrical energy into optical energy. An important feature of the xenon strobe lamp
is its ability to produce a high peak blue-white light output of short duration. All TOMAR strobe lamps have a
trigger coil potted into their assemblies except the low cost model 2001, 5001 and 5002 lamps.
ORDERING INFORMATION
SPECIFICATIONS
Electrical Notes
1. All lamps are triggered by discharging a 0.22 MFD
capacitor charged to 200 VDC into the trigger connection.
2. All lamps are polarity sensitive except the 6001.
3. Rubber friction mount base mounts in 1" Dia. hole.
W
I
R
I
N
G
C
O
N
N
E
C
T
O
R
S
Model Number Min Voltage MaxVoltage AvgWatts Base/Connector Note
2001 225 450 10 3 PIN AMP USE EXTERNAL TRIGGER
2002 225 450 10 3 PIN AMP
3001 180 600 20 OCTAL
4001 225 600 20 OCTAL
470–RL–CLEAR, RED, BLUE, AMBER 200 600 20 3 PIN AMP 6" WIRE LEADS
4701 (Note 3) 225 600 20 3 PIN AMP 6" WIRE LEADS
5001 225 400 5 3 PIN AMP USE EXTERNAL TRIGGER
5002 200 600 1 3 PIN MOLEX USE EXTERNAL TRIGGER
6001 225 800 40 OCTAL NON–POLAR
7001 600 2000 300 OCTAL–LARGE QUARTZ FORCED AIR COOL
9001 (Not Shown) 225 800 20 3 PIN AMP
PAR–36–ALL COLORS 225 600 20 3 PIN AMP
PAR–36E–RED, BLUE & AMBER 225 600 20 3 PIN AMP
PAR–56–ALL COLORS 225 600 40 3 PIN AMP
700–R1–ALL COLORS 180 600 20 3 PIN AMP
Octal Pin 2 – Anode, Pin 3 – Trigger,
(Except 7001) Pin6–– Cathode & Trigger Grd.
Octal Large Pin 2 – Anode, Pin 3 – Trigger, Pin 5 –
(7001 Only) Trigger Grd, Pin 6 – Cathode
3 Pin Amp Pin 1–– Anode, Pin 2 – Cathode,
Mate–N–Lok Pin 3 – Trigger
Pin 1 – Trigger HV, Pin 2 – Cathode,
Pin 3 – Anode
Pin 1 – Anode, Pin 2 – Trigger,
Pin 3 – Cathode
5001
2001
144534_Body r7.indd 48 11/8/11 1:54 PM