003-3818–091510B
Nautilus, Inc., (800) NAUTILUS / (800) 628-8458, www.NautilusInc.com - Customer Service: North America (800) 605-3369, csnls@nautilus.com | outside U.S. +01-360-859-5180, technics-APLA@nautilus.com | Printed in China | © 2010 Nautilus, Inc., All rights reserved. ™ and ® indicate a trademark or registered trademark. Nautilus, Inc. (www.NautilusInc.com) trademarks include NAUTILUS®, BOWFLEX®, SCHWINN® and UNIVERSAL® and respective logos. Other trademarks are the property of their respective owners.
Type Description A WARNING B Serial Number • • • • • • • • Do not allow Children to use this product. Inspect product before use. Do not use if any parts are in need of repair. Use Caution when using this equipment. Injury or death is possible if Caution is not used. Read and understand the Owners Manual prior to use. Replace this or other CAUTION, WARNING, or DANGER Labels if they become damaged or illegible or removed. This product is for Residential use only.
1. After you remove the dumbbell from its protective packaging, inspect the products and packaging material for damage. 2. Push down slightly on the handle assembly to make sure it is fully seated in the base. Rotate the adjustment knob several full rotations to make sure it turns freely in both directions. Make sure there is a click at each weight increment of the adjustment knob. This click will help you align the knob correctly to make a weight selection.
Testing the Locking Mechanism Function 1. With the dumbbell handle set in the dumbbell base, turn the adjustment knobs to the number 4. When you fully and correctly make the number selection, you can feel the adjustment knob move into a notch (known as a detent). You will also hear a small, but audible, click at the detent location for each number. 2. Pull the handle vertically from the base and all the weight plates will stay in the base. 3.
Item Qty A 4 Button Head Cap Screw M10 X 2 B 4 Flat Washer M10 Description Item Qty D 4 Description Lock Washer M10 Fully tighten the hardware before you put the dumbbells into the installed dumbbell bases on the stand. Maintenance Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular maintenance is done. Worn or damaged components must be replaced immediately or the equipment removed from service until the repair is made.
Adjustment knob will not turn while handle is in base. 1. Make sure that the dumbbell handle is fully pushed into the dumbbell base. If not fully set into the base, the locking mechanism will not be released and will prevent the adjustment knobs from turning. 2. Make sure that the weight plates are seated correctly in the base assembly. 3. Inspect the dumbbell base for dirt, debris or other unwanted material. If necessary, remove the weight plates from the base to do this check.
Printed in China