Owner's Manual

Erasing the Entire MX-350

To erase EVERYTHING, press and hold both the MAIN and the STOP

buttons for 15 seconds. After 15 seconds, the RESET screen appears.

Press the SURE button to erase all of your settings and return to the fac-

tory default setup.

Cloning One MX-350 to Another

If you own two or more MX-350, you can copy and transfer all the setup

from one MX-350 to another. Just follow these easy steps:

Enter SETUP mode by pressing and holding both MAIN and ENT

for three seconds.

Note: You have 30 seconds for each step, otherwise the MX-350 will time

out automatically.

Press a PAGE button to display page two of Setup.

Press the CLONE button.

Align the two MX-350 head-to-head, about an inch apart.

Press the RECV display button on the new MX-350 you would like to

setup by cloning.

Press the SEND display button on the MX-350 you previously setup.

Press the START button on the new MX-350 and then press the

START button on the MX-350 you previously setup.

Note: Cloning typically takes about 90 seconds.

After completion, the cloned MX-350 will flash “GOOD”.

Return to normal operation by pressing the MAIN button twice.

The MX-350

SURE

Button