Owner's Manual

Repeat steps one through nine for each of your devices. If you are

missing any commands, use the learning method, described next

Learning Method

The MX-350 can learn commands from your old remote controls one-but-

ton-at-a-time by following these simple steps:

Line-up the MX-350 with your old remote control, head-to-head,

one or two inches apart.

On the MX-350, press and hold the MAIN and ENT (Enter) buttons at

the same time for approximately three seconds. The top of the dis-

play will show “SETUP”. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If

you don’t press a button within that time, the MX-350 will time out and return to

normal operation.

Press the LEARN button.

The top of the screen will change to “LEARN”.

Universal Remote Control, Inc.

LEARN

Button