Installation manual

MRF-260
BASE
STATION "
Installation
1.
Unplug
the MRF-260.
Test
all
IR
commands and macros
line
of
sight.
2.
Power on
all AV
components including the
TV.
Turn on
all
of
the
lights and lower all
dimmers
to
50%.
Power on anything that
may create
RF
Interference
(particularly
devices
with
high speed
microprocessors or hard drives).
3.
Check that the address wheel
on the rear
of
the MRF-260
is
set
to
10#0 (the interference
"sniffing"
position).
Check that the
arrow
pointer in the center
of
the wheel
is
pointed
to
0,
the
default "interference sniffing" position.
If
it
is
not
,
use
a
small
flat
blade
screwdriver (included) to set the
RF
ID#
to
0.
4. Connect the MRF-260 to its DC
wall
adapter and
plug
the
wall
adapter into a
live
AC
outlet. Place
the MRF-260
in a
location
at
least
3 feet away from
satellite
receivers,
cable
boxe
s,
HDTV
tuners, DVRs,
PCs
or
any other device
with
a high speed micro-
processor (these generate broad band Radio Frequency
Interference
-RFI).
Of
course, you should
keep in mind that the
emitter
cables
are
1
0' long.
The r
ed
POWER
LED
indi-
cates that the MRF-260
is
powered on.
The red
STATUS
LED
flashes
differently, based on the
Address setting:
IF
SET
TO
ID#O
The Status LED flashes
when
it
rece
iv
es
ANY
RF
signal,
includin
g
RFI.
This
mak
es
ID#O
ideal for "s
niff
-
in
g"
out
RFI.
...
IF
SET
TO
ANY
OTHER
ID#
The
Status
LED
flashes
ONLY
when
it
receives a
co
rrectly
add
ress
ed
RF
command.
Page
3