Operating instructions

Technical Support
Comfort Panels
196 Operating Instructions, 03/2012, A5E03404994-02
8.4.3 Ambient conditions
8.4.3.1 Transport and storage conditions
Mechanical and climatic conditions for transportation and storage
This HMI device meets the requirements for IEC 61131-2 relating to transport and storage
conditions. The following specifications apply to the transport and storage of an HMI device
in its original packaging.
The climatic conditions conform to the following standards:
● IEC 60721-3-2, Class 3K7 for storage
● IEC 60721-3-2, Class 2K4 for transport
The mechanical conditions correspond to IEC 61131-2.
Type of condition Permitted range
Drop test (in transport package) ≤ 1 m
Temperature From –20 to +60° C
Atmospheric pressure From 1080 to 660 hPa,
Corresponds to an elevation of –1 000 to 3 500 m
Relative humidity From 10 to 90%, without condensation
Sinusoidal vibration in accordance with
IEC 60068-2-6
KP/KTP400 Comfort:
5 to 9 Hz: 3.5 mm
9 to 150 Hz: 9.8 m/s
2
KP/TP700 to 2200 Comfort:
5 to 8.4 Hz: 3.5 mm
8.4 to 500 Hz: 9.8 m/s
2
Shock according to
IEC 60068-2-27 for KP/KTP400 Comfort
IEC 60068-2-29
for KP/TP700 to 2200 Comfort
250 m/s
2
, 6 ms, 1000 shocks
NOTICE
Avoid dewing
If the HMI device is subjected to low temperatures or extreme fluctuations in temperature
during transportation, moisture could occur on or inside the HMI device. Dewing can occur.
This can cause malfunctions.
The HMI device must have acquired room temperature before it is put into operation. Do
not expose the HMI device to direct radiation from a heater in order to warm it up. If there is
condensation, wait approximately four hours until the HMI device has dried completely
before switching it on.
Proper transport and storage, installation and assembly as well as careful operation and
maintenance are required to ensure trouble-free and safe operation of the HMI device.
The warranty for the HMI device will be deemed void if these stipulations are not heeded.