User guide

43
SMDI Quick References
Commands to bring link down, BSY/RTS card, & restore link:
Note: The BSY/RTS of the SMDI link at the IOC level will automatically perform
the following commands:
>LNKUTIL
>SMDILNK
>SMDIDISC <vmail device name>
>DEVSTOP <vmail device name> SMDIDATA
>DEVDISC <vmail device name> KILL
>MAPCI;MTC;IOD;IOC <ioc>; CARD <SMDI card>
Note: IOC and CARD information can be found in table TERMDEV.
>BSY 0; RTS 0
>DEVCON <vmail device name>
>DEVSTART <vmail device name> SMDIDATA
>SMDICON <vmail device name>
>LNKSTAT ALL
Note: Should show transferring after entering this command.
>SMDISTAT ALL
Note: Should show routing.
The DMS accepts two kinds of incoming messages from the voice mailbox:
1. Message to activate the MWT indicator:
OP: MWI (SP) nnnnnnn! (D)
2. Message to deactivate the MWT indicator:
RMV: MWI (SP) nnnnnnn! (D)
The DMS sends two groups of outgoing messages to the voice mailbox:
1. Call Detail Messages:
(CR) (LF) MDqqqmmmmannnnnnn (SP) yyyyyyy (SP) (CR) (LF) (Y)
(CR) (LF) MDqqqmmmmannnnnnn (SP) (SP) (CR) (LF) (Y)
(CR) (LF) MDqqqmmmma (SP) yyyyyyy (SP)(CR)(LF)(Y)
2. MWT Change Failure Messages:
(CR) (LF) MWInnnnnnn (SP) INV (CR) (LF) (DL) (DL) (Y)
(CR) (LF) MWInnnnnnn (SP) BLK (CR) (LF) (DL) (DL) (Y)
where —
(SP) = space (CR) = carriage return
(D) = <ctrl>D (end of transmission)
(LF) = line feed (DL) = delete character (ASCII value FF)
(Y) = <ctrl>Y qqq = message desk number (001 - 063)
mmm = msg desk terminal or line number (0001 - 2047)
nnnnnnn = forwarding from station number (7 or 10 digits)
yyyyyyy = calling station number (7 or 10 digits)
a = type of call: D = direct calls A = forward all calls,
B = forward bsy calls N = forward no ans calls
To view incoming & outgoing messages (1X67FA)
>RECORD START FROM <vmail devicename>
>RECORD START FROM <vmail devicename>
To view incoming & outgoing messages (1X89 MPC Card)
XPMIST the MPC link or use the MONMPC CI: level command (see the next page
for MONMPC command).
SMDI continues on the next page.