User guide

38
DMS-250 Quick References
(NTP 297-2621-851, UCS DMS-250 Customer Data Schema Ref. Manual)
(NTP 297-2621-860. UCS DMS-250 CSP Translations Reference Manual)
(NTP 297-2621-814, UCS DMS-250 Operational Measurements Ref. Man.)
(NTP 297-2621-819, UCS DMS-250 Commands Reference Manual)
Trunk Group Types
DAL - Direct Access Line (PBX)
EANT - Equal Access Network Trunk (Feature Group D)
EDAL - Electronic Tandem network Dedicated Access Line
IMT - Inter-Machine Trks (Connect DMS-500 to other DMS 250/500)
ONAL - Off-Network Access Line (Feature Group A)
ONAT - Off-Network Access Trunk (Feature Group B and C)
PRA250 - Primary Rate Interface (ISDN)
DMS-250 Tables
ANISCRNU, ANISCUSP, ACSCRN2, AUTHDIN, AUTHCODU, COSS-
CRN,MULTIPIN, MULTICOS, PARTOSTS, PARTRANO, PATRRAN3,
PARTRANS, STSTOPAR, STSTRANO, STSTRAN3, STSRANS,
TRKGRP1, TRKCOS, UNRESDAT, UNRESDAY, UNRESTIM
QACCT Commands
The Query Account (QACCT) command manages information located in
the account code screening (ACSCRN2) table. QACCT replaces the
ACDQUERY command.
>QACCT HELP <topic>
>QACCT IDX <index number>
>QACCT DUMP <with entries or datafilled only>
>QACCT LIST <index number>
>QACCT COPY <from index to index>
>
QACCT DELETE <index number with entries prompt>
>QACCT FIND <account code digits>
AUTHTEST Command
The ACCTTEST (ACCT Code Test) command performs the following:
* validates the following account code types:
- authcode (AUTHACCT)
- authcode and a speed number (AUTHSNAC)
- automatic number identification (ANI)
- travel card number (TCN)
* translates an authcode-associated private speed number (AUTHSPEE) to
the destination number stored in the service control point (SCP)
>ACCTTEST AUTHACCT <adin authcode auth_acct timeout>
>
ACCTTEST AUTHSPEE <adin authcode speed_no timeout>
>
ACCTTEST AUTHSNAC <adin authcode speed_no authacct tim-
eout>
>ACCTTEST ANI <ani_no ani_acct timeout>
>ACCTTEST TCN <tcn_no tcn_acct timeout>
Travel Card Number Test (TCNTEST) Command
The Travel Card Number Test (TCNTEST) command verifies the integrity
of the travel card number (TCN) subsystem by validating calling card
numbers located at remote database location(s).
Restrictions:
• Each of the TCN subsystems must be in service.
• Remote database must be operational.
• Number of simultaneous users for the TCNTEST command is limited to
the number of users specified by office parameter
TESTSS_MAX_USERS (table OFCVAR).
Datafill must be located in the following tables:
- C7GTT
- C7GTTYPE
- C7LKSET
- C7LINK
- C7LOCSSN
- C7NETWRK
- C7RTESET
DMS-250 quick references continue on next page.