User guide

16
RTIF Commands and Recovery
(
NTP 297-YYYY-545, DMS-100 Recovery Procedures
)
Caution: Use the following only as a quick reference. Reference the NTP
for detailed procedures.
RTIF Restart Procedure
RTIF Boot Procedure
Activity Indicator
CPU of RTIF
Command
Entry Point
Sync Indicator
RTIF Terminal
Health Indicator
Flashing “A1”
\BOOT < > CM0 CPU 0 A1 Active NoSync OCpuClkOK 9X26OK CL
\RESTART < >
\JAM
\HELP
RTIF>
Step Active CPU Inactive CPU
Command Steps
1\JAM
2YES
3 \OVERRIDE
4 \RESTART WARM
5YES
Immediately
proceed to step
6
6 \OVERRIDE
7 \RESTART <type>
(types include Warm, Cold, Reload)
8YES
Watch For
•Restart is complete when ‘A1’ flashing on active RTIF terminal.
•Maximum Time to ‘A1’ flashing = 3 mins……..Processor Dependent.
Only Perform if Switch is in sync
*
Step Active CPU Inactive CPU
Command Steps
1\JAM
2YES
3 \OVERRIDE
4 \RESTART WARM
5YES
6
6
7
8
\OVERRIDE
\BOOT <SLM0, SLM1, SLM0T, SLM1T>
YES
Watch For
•Restart is complete when ‘A1’ flashing on active RTIF terminal.
•Maximum Time to ‘A1’ flashing = 20 mins……..Processor Dependent.
Only Perform if Switch is in sync
Immediately
proceed to step
*