User guide

13
LOGUTIL Info, Control, Routing, and
Devices Commands
(NTP 297-1001-129, Input/Output System Reference Manual)
Note: LOGUTIL should only be used as a temporary measure for log con-
trol. Tables LOGCLASS, LOGDEV, and TERMDEV should be
used for permanent control of logs. Unless there is a clear under-
standing of the use of the following commands and the potential loss
of log reports, they should not be used.
Note: See the REMLOGIN command within the Tier II Support Tools
area of this QRG.
>HELP LOGUTIL lists LOGUTIL commands.
>LOGUTIL access to LOGUTIL commands.
>QUIT or LEAVE quits LOGUTIL.
>ADDCLASS adds output report classes to specified primary IOD.
>ADDREP adds more reports to specified primary IOD.
>
BACKUP
assigns alternative IOD to back up primary IOD.
>CLASS assigns report class #’s to specified output reports.
>CONTEXT allow the user to change the context of applicable
nodes without having to use the REMLOGIN com-
mand (use LISTNODES command for list of nodes).
>
DELCLASS
deletes specified report classes with specified IOD.
>DELDEVICE deletes specified IOD from receiving log reports.
Note: Must use
STOPDEV
command first.
>DELREP deletes specified report(s) from specified IOD.
>LISTDEVS displays status of each IOD associated with log system.
>
LISTREPS SPECIAL
displays a list of special log reports that have
special routing or thresholding, and those suppressed.
>
LISTREPS SYSLOG
displays only syslog reports.
>LISTREPS CLASS displays a list of reports by log class.
>DUMPLOGS <logname> <log number> display specified log reports
in a buffer in the chronological order as they were
generated.
>LOGTRACE ON/OFF <logname and number> turns ON/OFF the
traceback feat. (a LOGT is generated for each rep).
>RENUMBER assigns a report # to all report types not assigned.
>LISTROUTE displays specified report classes, report names, and
IOD, by CLASS, DEVICE, or REPORT.
>
LISTNODES
list all nodes in the switch.
>LISTTIME displays log reports on a threshold reset schedule.
>LISTLOGS list all lognames, except SECRET lognames.
>RESET resets to zero all threshold values that were applied.
by
THRESHOLD
and resumes
SUPPRESS
reports.
>
REROUTE
reroutes reports from primary IOD to backup IOD.
>RESETROUTE restores the temporary routing of output reports.
>
RESUME
resumes the output reports previously suppressed.
>START starts log reports to specified device.
>STOP stops printing of reports on specified device.
>STOPDEV stops the output of reports to the specified device(s).
>
STARTDEV
starts the output of reports to the specified device(s).
>
SUPPRESS
suppresses specified output reports.
>THRESHOLD sets a threshold value for specified report(s).
>TIMERESET sets a time value for the threshold counter.
LOGUTIL Log Browsing Commands
(NTP 297-1001-129, Input /Output System Reference Manual)
Note: See the REMLOGIN command within the Tier II Tools area of
this QRG.
>OPEN access to display log subsystem or SYSLOG buffers.
>FIRST displays oldest report in the current log subsystem.
>LAST displays most recent report in current log subsystem.
>FORWARD <number or ALL> displays report(s) after current one.
>BACK <number or ALL> displays report(s) before
current one.
>CLEAR deletes all reports from specified log subsystem buffer.
>FORMAT queries or sets the NORMAL or SHORT format in
which output reports will be printed.
>TYPE re-displays the report in the current log subsystem.
buffer that was previously displayed by commands
LAST, FIRST, BACK, and FORWARD.