User guide

148
T
I
E
R
II
S
U
P
P
O
R
T
T
O
O
L
S
XPMIST Call Processing Messages
(TAM-1001-007 PMIST User Guide)
ABANDON_MSG Trunk exited during digit collection.
ANI_MSG Reports results of ANI identification on
party line.
ANSWER_MSG Terminal answered the call.
ATD_RESULT_MSG Reports results from an audio tone
detector.
CALL_ABANDONED_MSG Line exited during digit collection.
CALL_FAILURE_MSG Terminal detected call failure.
CHANNEL_BLOCKING_ Call blocked in XPM (no P-side
MESSAGE channel).
CLEAR_BACK_MSG Outgoing trunk exited.
CLEAR_FORWARD_MSG Incoming trunk exited.
COIN_MSG Reports results of a coin control
function on a coin line.
CONF_AVAILABLE Conference circuit now available (after
queueing).
CONFUSION_MSG Terminal detected a supervision error.
CPOS_AVAILABLE CAMA position now available.
CPWAKEUPMSG Reports time-out from the CP wakeup
utility.
DGT_RECEPTION_ERR_MSG Error detected during DTMF digit
collection.
DIGITS_MSG Reports dialed digits; collection
continuing.
DIGITS_SENT_MSG Outgoing trunk has finished outpulsing.
DM_REPORT_MSG Reports key hits from TOPS, AOSS,
IBN AC.
DP_RECEPTINO_ERR_MSG Error detected during DP digit
collection.
EXIT_MSG Line exited.
FEATURE_MSG Requests invocation of an FPE feature.
FLASH_MSG Terminal flashed.
GLARE_MSG Glare detected on a trunk.
INTEG_FOUND_MSG Terminal found integrity.
INTEG_LOST_MSG Terminal lost integrity.
INTRA_BLOCKING_MSG XPM couldn't intraswitch; reroute
through NMs.
LAST_DIGITS_MSG Reports dialled digits; collection
stopped.
LOCKOUT_MSG Terminal failed to idle properly.
OPERATOR_CONTROL_MSG Winks detected on an operator trunk.
ORIG_DIGITS_MSG Trunk wishes to originate a call; digits
collected.
ORIG_KEY_MSG PPhone wishes to originate a call on
non-DN key.
ORIGINATION_MSG Terminal wishes to originate a call.
PREEMPT_CLEAR_MSG Autovon trunk exited due to other-end
preempt.
PREEMPT_INTERNAL_MSG From preempting call to preempted call.
PREEMPT_REUSE_MSG Release Autovon trunk for use by a new
call.
RCVR_AVAILABLE RCVR now available (after queueing).
RCVR_ERROR_MSG Error detected during digit reception.
RELEASE_CALL_MSG Terminal is to be force released.
REMOTE_BUSY_MSG Line is to be force released.
REMOTE_DATABASE_ Response received from DCP (US
CP_NOTICE_MSG Sprint).
RINGING_TROUBLE_MSG Error detected during ringing of line.
ROUTING_MSG Causes setup processor to invoke router.
SA_MSG Reports results to service analysis
system.
SEIZED_MSG Outgoing trunk seized successfully.
SVCT_AVAILABLE Sender now available (after queueing).
TREATMENT_MSG Causes setup processor to apply
treatment.
UTR_DENIED XPM could not obtain receiver for digit
collection.
WINK_MSG Wink detected on a CAMA trunk.
XPM1_CC_FEATURE_MSG Feature message requested from XPM,
0-63.
XPM2_CC_FEATURE_MSG Feature message requested from XPM,
64-127.