Manualshelf

User's Manual

ManualsBrandsUniversal Remote Control ManualsUniversal RemoteUniversal Remote Control CONTROL WR7
11121314151617181920
Page 14
Auto-Search Method
The Auto-Search Method is a way you can scan through
all of the codes in the table to find the right code for
your component.
STEP 1: Manually or using your old remote, turn on the
component you want to program—for example, to program
your TV, turn on your TV set.
STEP 2: On the WR7, press the Component button
that you want to program (in this case the button that says
TV) and the SELECT [SEL] button at the same time. Hold
down both buttons for two seconds until the TV Component
button light turns on. This signals that you are in
programming mode.
IMPORTANT: You have 30 seconds to perform the next
step while you are in programming mode. If you do not
press a button within 30 seconds, the component LED light
will turn off. The remote will exit the programming mode
and you will have to start over.
UP
ARROW
DOWN
ARROW
WR7 1/13/08 12:18 PM Page 14