Manual

First Steps
AIR SPACE
Installation
LE_/EUNG FEET
Unpackingand Levelhqg- Upright Freezers
RE3N8
TOP _C
HINGE _ _
i HINGE COVER
Upright Freezer Door Removal
F_I_! Toallow doorto
closeand seal properly, DO NOT let
food packages eetend paetthe from
of shelves,
Before starting the freezer, follow these important first steps:
Installation
• Choose a place that is near a grounded electrical outlet.
• For the most efficient operation, the freezer should be located where surrounding
temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and below
will NOT affect freezer operation. Additional compressor heaters are not recom-
mended.
• AtlowspacearoundtheunitYorgoodaircircutation. Leave a 3 inch (75 mm)space
on all sides of the freezer for adequate circulation.
Leveling
The freezer must have all bottom corners resting firmly on asolid floor. Thefloor must
be strong enough to support afully loaded freezer. NOTE: It isVERYIMPORTANTfor
your freezer to be level in order to function properly. If the freezer is not leveleddu ring
installatioin, the door may be misafigned and not close or seal properly, causing
cooling, frost, or moisture problems.
To Level Upright Unit:
After discarding crating screws and wood base, use a carpenter's level to level the
freezer from fronbto-back. Adjust the plastic leveling feet in front, _f2bubble higher,
so that the door closes easily when left halfway open.
To Level Chest Unit:
If needed, add metal or wood shims between feet pads and floor,
Cleaning
• Wash any removable parts, the freezer interior, and exterior with mild detergent
and warm water. Wipe dry. DO NOT USE HARSH CLEANERS ON THESE
SURFACES.
Do not use razor blades or other sharp instruments, which can scratch the appliance
surface when removing adhesive labels. Any glue left from the tape can be
removed with a mixture of warm water and mild detergent, or touch the residue
with the sticky side of tape already removed. DO NOT REMOVE THE SERIAL
PLATE.
Upright Freezer Door Removal
If door must be removed:
1. Lift up plastic hinge cover and fold back.
2. Usea Phillips,) screwdriver to loosen and retighten the screws on the top hinge to
ensure that a secure assembly and prevent hinge slippage.
3. Remove the top hinge from cabinet and lift door off the lower hinge pin.
4. After door is removed, remove the two screws from the bottom hinge.
5. To replace door, reverse above order.
Shelf Front
4