Manual

ManualsBrandsUniversal/Multiflex (Frigidaire) ManualsFreestanding FreezerOfficial Universal/Multiflex (Frigidaire) freezer

First Steps

Installation

_ : L_IEUNG REET

Unpackingand Leveling - Upright Freezers

_Base PanelScrews

__Base Panel

, W Hinge Screws

/ Hinge

Figure 1

_To allowdoorto

closeandsealproperly,DO NOTlet

fondpackagesextendpastthefront

of shelves.

Shelf Front

Before starting the freezer, follow these important first steps:

Installation

• Choose a place that is near a grounded electrical outlet.

• Forthe most efficient operation, the freezer should be located where surrounding

temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C)and below

will NOT affect freezer operation, Additional compressor heaters are not recom-

mended.

• Atlow spacearound the unit forgoodaircirculation. Leave a 3 inch (75 mm) space

on attsides of the freezer for adequate circulation,

Leveling

The freezer must have all bottom corners resting firmly on asolid floor, Thefloor must

be strong enough to support afully loaded freezer, Check the cabinet with a levelfrom

side to side. After discarding the crating screws and wood base, level the cabinet.

TOLevel Upright Unit:

Once leveled, slightly raise adjustment of front feet so the door closes easily when

opened about halfway.

To Level Chest Unit:

If needed, add metal or wood shims between feet pads and floor.

Cleaning

• Wash any removable parts, the freezer interior, and exterior with mild detergent

and warm water. Wipe dry. DO NOT USE HARSH CLEANERS ON THESE

SURFACES.

• Do not use razor blades or other sharp instruments, which can scratchthe appflance

surface when removing adhesive labels, Any glue left from the tape can be

removed with a mixture of warm water and mild detergent, or touch the residue

with the sticky side of tape already removed. DO NOT REMOVE THE SERIAL

PLATE,

Door Removal (upright models)

If door must be removed to fit through narrow doorways:

1, Gently lay freezer on its back, on a throw rug or blanket,

2. Remove base panel (some models) by unscrewing two screws from front of base

panel, (Figure 1)

3. At top of cabinet, lift up plastic hinge cover and fold

back, (Figure 2)

4. Usea Phillips@ screwdriver to loosen and retighten

screws on top hinge to insure a secure assembly and

prevent hinge slippage.

5. Remove top hinge from cabinet. Lift door off lower

hinge pin,

6. After door is removed, remove the two screws from

bottom hinge,

7. To replace door, reverse above order.

8CREWS

HINGE

I HINGE COVER

UPRIGHT FREEZER DOOR ADJUSTMENTS

Figure2