User guide

Link to Table of Contents
User Guide
228
ULS Reference Guide Book
Observe the “V” groove along the upper (3) and lower (2) part of the laser cartridge base plate and the 3.
alignment plate (1) at the end of the base plate.
Pick up the laser cartridge by the ends and tilt it at a 30 degree angle as shown (1). Mount the cartridge onto 4.
the mounting blocks shown in step 2 (page 229) by placing the upper “V” groove on top of the mounting
blocks. Slide the cartridge to the right until the outer edge (2) of the alignment plate contacts the inside edge of
the large plate of the alignment fork.