User guide
Link to Table of Contents
User Guide
98
VLS3.60, VLS4.60 and VLS6.60 Accessories
CORRECT INCORRECT
TOP VIEW
FILTER
Removal, Cleaning and Replacement of the Filter
Turn the Air Compressor OFF and unplug it.1.
Unscrew the cover by turning it 1/8 turn counterclockwise like you were unscrewing a jar, and pull down. 2.
The clear plastic container might still remain attached to the top. Gently pull this part straight down.
You will see a red colored foam lter. Unscrew the lter and wash it out with water. Make sure that it is 3.
completely dry, then reinstall.
Empty and clean out any residue or dust that may have accumulated on the bottom of the clear plastic 4.
container.
Install the clear plastic container into the cover and line up the tabs so that they t one inside of the other.5.
Insert the combination of the cover and the clear plastic container into the top of the assembly. Gently twist 6.
the cover 1/8 turn clockwise to lock it into place.
DESICCANT
CLEAR
CONTAINER
METAL COVER
LATCH
TOP
DRYER
ASSEMBLY
Removal, Cleaning and Replacement of the Desiccant
Turn the Air Compressor OFF and unplug it.1.
Pull down on black lever and rotate metal cover 1/8 turn counterclockwise. Remove the metal cover by 2.
pulling it straight down.
With a gentle and slight twisting motion, pull the clear container downward slowly. Pour out and discard 3.
old desiccant.
Rell clear container with fresh desiccant from a sealed bag. Fill to about ¼ inch from top of container.4.
Clean o rubber o-ring on the top of the container.5.
Insert container into the top.6.
Install metal cover and turn 1/8 turn until lever clicks into place.7.